Page 1
V ER SAT I L E > IN T EG RAT ED > O P EN > EF FIC IE NT QUICK START GUIDE...
Page 2
# Container Connect the PL900S Mill Power Supply Connection on the rear $ Storage drawer using the supplied US Power Cord. Turn on the Power Switch at the rear to start the PL900S Mill. Interior LCD DISPLAY ICONS ! Blank holder...
Page 3
OPERATION OF THE MILL MATERIAL AND TOOL HOLDER HOLDER CHANGE ! Screw for holder replacement To change the blank holder: @ Screw for blank fastening With the door shut, select DEPOSIT TOOL function at the operational display. The # Blank holder current tool is placed down.
Page 4
CLEANING TOOL CHANGE CLEAN THE INTERIOR (WEEKLY) If you want to change the worn out Tool – Press the CLEANING button. release the it from the marked slot in the holder (magneticly fi xed) and insert the new one. Press the INTERIOR button.
Page 5
SPINDLE SERVICE – CLEANING THE COLLET (WEEKLY) ! Collet grease Clean the collet holder using the felt cone # . The collet holder must be free @ Collet brush of shavings/chips and debris. # Felt cone $ Ejector pin % Spindle wrench Press the CLEANING button.
Page 6
REPLACING COOLANT AND FILTER IN THE WATER TANK (WEEKLY) Press the CLEANING button. Clean tank with brush. Rinse tank with clean water. Remove the fi lter protection foil from the new fi lter. Press the TANK button. ...
Page 7
CLEANING MAINTENANCE SCHEDULE DATE WEEKLY MONTHLY Change: Water Tank, Clean: Spindle, Clean: Interior of Milling Coolant/Lubricant Collet, Collet Holder, Check: Calibration Chamber and Drain Screen and Filter C/L Nozzles For the week of Done Done Done Done...
Page 8
V E RSAT I L E > IN T EG RAT ED > O P EN > EF FIC IE NT by �amanngirrbach Manufacturer: Amann Girrbach AG Koblach, Austria info@idc.dental www.idc.dental All products produced and assembled in Austria & Germany...
Need help?
Do you have a question about the PL900S and is the answer not in the manual?
Questions and answers