Sceptre X37SV-Naga Manual page 27

Problems
Can not receive UHF
Can not receive sufficient
channels through antenna
No colors
Blinking picture accompanied
By ghost image
Broken lines or segments
Certain TV channels are
blocked
Can not access a picture or
audio menu
Cannot view 2 channels at the
same time with PIP
No Universal Remote Code
TV has colors of lines across
the screen
TV is turned on, stand by light
is green but no picture
No Picture on PC (DVI port)
No Sound on PC
Satellite / Digital Cable box
says HDCP not compatible
Satellite / Digital Cable box
has no video on HDMI port
All manuals and user guides at all-guides.com
Possible solutions
Change the signal line to other input-end, make sure your antenna is capable
of receiving UHF.
Please use the channel scanning function to increase the number of channels
Please adjust the color setup, and make sure your signal cable is tightly
connected.
Check the connection of antenna/signal cable
Adjust antenna. Keep the TV away from noise sources such as
neon lights, and hair dryer.
Please use the channel scanning function or v-chip function to unblock.
Make sure your Picture / Sound are both on "User Mode" by pressing the
"Picture" button until the upper left hand corner says "User Mode". Please
do the same regarding "Sound" button
The PIP function is not designed to view 2 channels at the same time.
This television is not designed with a universal remote code.
This is a big LCD screen, it takes time for electricity to charge up to power
the screen and takes time for the large screen to deplete all it's residual
electricity. Please do not turn the TV on and off really quickly. Between
the time which you turn off the TV and the time which you turn it on, there
should be at least 50 seconds to 70 seconds.
This is a big LCD screen, and needs time to warm up to show the picture,
please wait for 15-30 seconds for the picture to show up.
Is your video card's DVI port turned off by default? Go into your video
card's advance menu to make sure 2
Make sure your green connector head audio cable is connected.
Reboot your satellite / digital cable box by turning them off then unplugging
the power cord. Wait for at least 1-3 minutes and plug them back into the
wall and turn on the power.
Make sure you're using the HDMI->HDMI cable. If you're using the cable
we've included in the box, then you should set your source to HDCP or DVI.
27
nd
monitor / DVI port is turned on