Central Machinery 03173 Assembly And Operating Instructions Manual page 6

Brought To You By Augusta Flint
2. CAUTION: Always make sure the On/Off Power Switch, located on the
Power Cord of the High Speed Motor Unit (part #4-A) is in its "OFF" posi-
tion prior to plugging the 12 Volt Transformer (part #58) into a grounded,
120 volt electrical outlet.
(See Figure A.)
3. To supply electrical power to the Woodturning Lathe, plug the Power Cord of the
High Speed Motor Unit (part #4-A) into the outlet of the 12 Volt Transformer
(part #58).
(See Figure A.)
4. Then, plug the Power Cord of the 12 Volt Transformer (part #58) into a grounded,
120 volt, electrical outlet. (See Figure A.)
To Connect The Parts, Using The Connection Pieces:
1. Each of the main parts of the Woodworking Lathe features one or more "T"
Slots with which to connect one part to another. (See Figure C.)
2. As an example, the High Speed Motor Unit (part #4-A) and the Wheel Gear Box
(part #6) will be used to illustrate how the two parts, as with other parts, are
connected together. (See Figure C.)
CONNECTION PIECE (#19)
SCREW
(#84)
HIGH SPEED MOTOR UNIT (#4-A)
"T" SLOT
CONNECTION PIECE (#19)
SKU 03173
NUT (#93)
WHEEL GEAR BOX (#6)
PAGE 6
DRIVE BELT (#15)
SCREWDRIVER
(NOT INCLUDED)
FIGURE C