All manuals and user guides at all-guides.com
wireless performance will be depending on the strength of your Wireless module in your
home router. Please make sure that the signal between your home router (N-type router
recommended) and the PConTV device is good to ensure good performance.
Check the <Enable> button to activate AP-Client mode. Click on the magnifier glass to
search for your home router SSID. Click OK to save the settings.The PConTV will reboot
and connect to your home WiFi router (It may take 30-40 seconds for the PConTV to
retrieve an IP address from your home router. Your home router needs to be able to
deliver IP addresses to clients in DHCP mode (most routers are in DHCP mode by
default).
When your router is set to only work with Static IP addresses you can configure the
PConTV with a static IP address through the device management webpage under the tab
Network Setup. When there is no IP addresses delivered to the PConTV (as presented in
the lower left corner on the TV startup screen) the quality of signal of your home router
may be too low. In this case try to setup the PConTV in a wired setup (using Ethernet
cable or power line modem to connect to your home router). When the PConTV is
wirelessly connected to your home router successfully you need to reconnect to the
PConTV from the PConTV Software user interface using the same password as your
home WiFi router when asked for a password.
Need help?
Do you have a question about the MD-300 and is the answer not in the manual?