Table of Contents
Advertisement
2 – Part names and functions
Rear panel
/
POWER switch
/
Press to turn the power ON and OFF.
~ IN
!
Use the supplied power cord to connect the amp
to an AC power outlet. Confirm that the voltage
matches that marked on the rear panel of your
GA-100CD amp.
CD/EFFECT FOOTSWITCH jack
@
Use a TASCAM RC-30P or similar footswitch
to control playback/pause, bank number, tuner
operation and other functions. Dual footswitch use
is possible. (See "Changing settings" on page 21.)
GUITAR CHANNEL FOOTSWITCH jack
#
Use a TASCAM RC-30P or similar footswitch to
change between clean and overdrive channels.
EFFECT SEND
and
RETURN
$
Use these to send the guitar signal to an external
effect loop after it has passed through the
GA-100CD's preamp.
1
TASCAM GA-100CD
!
@
#
jacks
$
%
^
LINE IN (L, R) jacks
%
Connect an external line level (-10 dBV) signal from
a synthesizer, guitar preamp, MD player or other
device. The signal from the external device is output
through the sub-speakers.
LINE OUT (L, R) jacks
^
Outputs the mix of
MAIN MASTER VOLUME
SUB MASTER VOLUME
from the
jacks at –10 dBV levels.
LINE IN
PHONES jack
&
Connect standard stereo headphones to this 1/4"
jack to listen to CDs or practice alone.
Outputs the mix of
MAIN MASTER VOLUME
SUB MASTER VOLUME
input signal from the
LINE IN
NOTE
When the Phones jack is in use, the GA-100CD will
not output sound from its speakers.
&
and
signals and the signal
and
signals along with the
jack.
Advertisement
Table of Contents
