Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DIGITAL YACHT Aqua Wear WLN20
Summary of Contents for DIGITAL YACHT Aqua Wear WLN20
- Page 1 AQUA WEAR WLN20 WIRELESS NMEA SERVER...
-
Page 2: Before You Start
1. Introduction Congratulations on the purchase of your Aqua Wear WLN20 Wireless NMEA Server. It is recommended that your product is installed by a professional installer, particularly when it comes to interfacing with other equipment. Before installing and operating this unit you should consult the user manual of the navigation equipment that you are connecting this unit 2. - Page 3 When locating the unit you should consider: Routing of power cables to the unit. Provision of sufficient space around the unit for cable connections Routing of NMEA data connections to/from the NMEA 0183 device. Maintaining the compass safe distance of 0.5m. ...
- Page 4 Installation Step 3 – Powering the WLN20 Provide power connections to the unit. Power is connected to the ten core PWR/DATA cable on the Red and Black wires. Red wire is the positive (+) connection, Black wire is the negative (-) connection. ...
- Page 5 Installation Step 5 – Applying Power Apply power to the WLN20 and you should see the four LEDs start to illuminate or flash. The following table shows what each LED indicates; Red LED Yellow LED Yellow LED Green LED Condition “STATUS”...
-
Page 6: Normal Operation
If you wish to connect multiple devices to the WLN20, then all devices must use UDP mode. If the first device to connect is set to TCP mode then no other devices will be able to connect Once you have wirelessly connected your mobile device to the WLN20, you will need to run the application on your mobile device that accepts NMEA data over a TCP or UDP connection.
Need help?
Do you have a question about the Aqua Wear WLN20 and is the answer not in the manual?
Questions and answers