Rear Panel - Tascam MD-02 Owner's Manual

2 − Names and Functions of Parts

Rear panel

MD-02
MD-02B
ANALOG IN L/R (UNBALANCED)
h
These analog line input jacks (RCA pin jacks) have a
nominal input level of –10 dBV.
ANALOG OUT L/R (UNBALANCED)
j
These analog line output jacks (RCA pin jacks) have a
nominal output level of –10 dBV.
These output the selected input signal during recording,
when in recording standby and when monitoring.
DIGITAL IN (COAXIAL)
k
This coaxial digital input jack conforms to IEC60958-3
(S/PDIF).
Since this deck has a sampling rate converter, in
addition to 44.1 KHz signals, 32 and 48 KHz digital
signals can also be input.
DIGITAL OUT (COAXIAL)
l
This coaxial digital output jack conforms to
IEC60958-3 (S/PDIF).
This outputs the selected input signal during recording,
when in recording standby and when monitoring. When
a digital input is selected, that digital input is output
unchanged.
DIGITAL IN (OPTICAL)
;
This optical digital input jack conforms to IEC60958-3
(S/PDIF). Since this deck has a sampling rate converter,
in addition to 44.1 kHz signals, 32 and 48 kHz digital
signals can also be input.
10
TASCAM MD-02/MD-02B
z DIGITAL OUT (OPTICAL)
This optical digital output jack conforms to
IEC60958-3 (S/PDIF).
This outputs the selected input signal during recording,
when in recording standby and when monitoring. When
a digital input is selected, that digital input is output
unchanged.
ANALOG INPUT (BALANCED) (MD-02B only)
x
These analog input jacks (balanced XLR) have a
nominal input level of +4 dBu.
(1: GND, 2: HOT, 3: COLD)
ANALOG OUTPUT (BALANCED) (MD-02B only)
c
These analog output jacks (balanced XLR) have a
nominal output level of +4 dBu.
(1: GND, 2: HOT, 3: COLD)
These output the selected input signal during recording,
when in recording standby and when monitoring.
~ IN connector
v
Connect the included power cord.