Tascam MD-350 Service Manual
Minidisc deck
Hide thumbs
Also See for MD-350:
- Owner's manual (112 pages) ,
- Technical documentation (2 pages) ,
- Consultant’s specification (1 page)
Table of Contents
Advertisement
Advertisement
Table of Contents
Need help?
Do you have a question about the MD-350 and is the answer not in the manual?
Questions and answers
how to trouble shoot the mechanism for not ejecting the disc
The Tascam MD-350 disc ejection mechanism can be troubleshooted using the following steps:
1. Check the MiniDisc Type: Ensure that the MD is not write-protected or damaged. If the MD is not recordable, replace it with a recordable one.
2. Power Cycle the Unit: Turn off the power and turn it back on after a few moments. This may reset the ejection mechanism.
3. Check for UTOC Writing Errors: If the "UTOC Writing" indicator is flashing, do not interrupt the process by removing power or shaking the unit, as this may corrupt the disc.
4. Remove and Reinsert the Disc: If the MD is stuck, try reinserting it properly. Make sure no labels are peeling off, which could cause the disc to jam.
5. Check Power Supply: Ensure the power source is stable. If the power was off for too long after recording, eject the disc after turning the unit back on.
6. Inspect for Physical Obstructions: Ensure nothing is blocking the disc slot or interfering with the ejection process.
If the issue persists, professional servicing may be required.
This answer is automatically generated
the eject mechanism does not always eject the disc