Using Your Alarm Clock - homelabs HME040049N Manual

Using Your Alarm Clock

Set Up Your Clock
1. Insert one CR2032 battery into the
back of clock. Note that the battery is
for backup power only.
2. Connect to DC 5V power.
Set the Time
1. Hold the Current Time button for 3
seconds until the hour time begins to
blink.
2. Use (+) and (-) to adjust the hour.
3. Touch the Current Time button to
confirm the hour time and move on
to minutes.
4. Use (+) and (-) to adjust the minutes.
5. Touch the Current Time button once
more to confirm.
Program Your Sunrise Alarm
1. Hold for 2 seconds to enter Alarm
setting mode.
2. Use (+) and (-) to adjust the time. Tap
Alarm Option button to confirm.
3. Use (+) and (-) to set up alarm light
rising time: 10/20/30/40/50/60 min/
OFF. Tap Alarm Option button to
confirm.
4. Use (+) and (-) to select the alarm
light color (from C1 to C8, C2 being
the cycling color). Tap Alarm Option
button to confirm.
Set Your Alarm Tone
1. Press the Alarm Tone button to
choose a tone.
2. Use (+) and (-) to select between 7
sounds. Tone 1-6 consist of nature
sounds, while tone 7 plays FM radio.
"Program the Radio".
3. Wait for clock to return to standby
mode, then press
volume. You must not be in "Tone",
"Light", "Radio", or any other mode.
4. Press the Alarm Tone button to
confirm your tone.
NOTE: Alarm volume and radio volume
are adjusted separately.
or to adjust
Adjust Sleep Timer
1. Touch the Sleep Timer button to
initiate sunset simulation.
2. Touch the Sleep Timer button once to
set at 15 minutes. Light will gradually
dim until it turns off over the course
of 15 minutes.
3. Touch the Sleep Timer button a
second time for sunset simulation
over 30 minutes.
4. Touch the Sleep Timer button three
times for 60 minutes.
5. Touch the Sleep Timer button four
times to turn off.
6. Leave for 5 seconds to confirm
selected option.
Adjust Light
1. Press the LED Light button once to
turn on the light (warm white).
2. Use (+) and (-) to adjust between 10
levels of brightness.
3. Press the LED Light button a second
time to switch to cycling color.
4. Use (+) and (-) to choose the other 6
colors: red, green, orange, pink, blue, and
light green.
Adjust Display Brightness
1. Press the Display Brightness button to
choose between three different LED
display intensities: low, high, and off.
2. The clock will automatically display
the brightest intensity during
programming but will resume to the
chosen option after 5 seconds.
Adjust Volume
1. Select the Lower Volume button to
lower the volume.
2. Select Raise Volume button to raise
the volume.
Program the Radio
1. Press this button to play the radio.
7