Function Presentation - Beko ATP8100 User Manual

3 Functions presentation
Display panel
1. On/Off
Make sure the power connected with Air Purifier. Then, music will come out with light flickering. Press
the keypad to be on. Press On/Off button to enter Auto mode. Then, the buzzer rings three times and
the red indicator light turns on. when the air quality light band flashes with 6 colours in an alternative
order (if the machine is not unplugged after the switch is off, the colour displayed in the light band
will be the default colour before the machine is shut down, and there is no alternate flashing); after
8 s, the machine begins the process of air quality information-sampling. The light will display different
colour based on the quality of the air it has collected. When the light turns blue, the purification will be
carried out with low gear. When the light turns red, the purification will be carried out with high gear.
And when the other two colours are displayed, the purification will be carried out with middle gear.
Warning
A
At first use or having not been used for a long time, when powering on the machine,
there are fine dust particles covered on the sensors, so it needs around 30-60 minutes
to pre-heat and then functions will be stable. Before stable status, the data for
displaying PM 2.5 is only for reference.
2. Modes and speeds selection
Three Modes are set for selection. We would suggest select the silent mode in the night or any
environment that needs silentmode. In the daily use, Auto/Turbo mode can be set.
The machine has low, middle and high gear of wind speeds for users to select manually. And to be
more specified, the highest speed is available in Turbo mode, while the lowest is for silent mode which
is only activated under silent mode.
7 / 40 EN 8 / 76 EN
Air purifier / User Manual
Airpurifer / User Manual