Making Control Connections; Power Connections; Block Diagram - Tascam DA-45HR Owner's Manual

1 - Introduction to the DA-45HR
the word clock master for a digital audio
setup, any word clock slaves should receive
the clock through the digital audio signal.

1.5.4 Making control connections

The optional RC-D45 remote control unit may be
connected to the REMOTE IN jack, using the 5 m
(approximately 16 ft) cable of the RC-D45.

1.6 Block Diagram

8
TASCAM DA-45HR
WARNING
Do not attempt to use the tape deck with any
remote control unit except one designed
especially for use with this tape deck.
The CONTROL I/O connector is for use with suit-
ably-equipped control units (see CONTROL I/O
[36]).

1.5.5 Power connections

Make sure that your AC voltage supply matches the
voltage requirements of the tape deck (as printed on
the rear panel).