IconBiT SMART SCOOTER User Manual page 11

8. Charging your scooter
Step 1: Ensure that the charging port is clean and dry. Make sure that there is no dust, debris or dirt inside the charging port.
Step 2: Plug the charger into the wall, then connect the cable with the power supply (100V ~ 240V; 50, 60 Hz), make sure the light on the charger is lit GREEN.
Step 3: Connect the charging cable into the charging port of the scooter. The indicator light on the charger should change to RED, indicating that your scooter is now being
charged. When the RED indicator light on your charger turns to GREEN, then your scooter is fully charged. A full charge typically occurs within 2-3 hours.
Step 4: Please unplug the charger from your scooter and from the power outlet.
Important Notes About Charging
If the GREEN light on your charger does not turn RED when you plug it into your scooter, it could mean you have to check the cables to ensure you have a proper
connection; or that your scooter is already fully charged. Push and hold your power button next to the charging port to check the status of your battery in the display.
Do not overcharge, as this will a ect the life of the battery.
The best charging temperatures are between 0° ~ 40°. Extreme cold and extreme heat will prevent your battery from charging fully.
Make sure to unplug your charger before standing on or operating your scooter, as this can be very dangerous.
Use only the scooter charger that you received in your box.
If the scooter is powered on when you enter the plug, the Battery Indicator will begin blinking, if the scooter is powered o when you enter the plug, the Battery Indicator
will not blink.
NOTE - Only the indicator light on the charger will tell you the status of the battery during charging.
English 9 / 12