Sony JCC-VIR978D Quick Start Manual

JCC-VIR978D
1/3" Color SONY IR Dome Camera
FEATURES
Color camera with SONY 1/3" Super HAD High Res. CCD
sensor.
Employs SONY Digital Signal Processor (DSP) IC for image
control.
Pixel number: NTSC=380K / PAL=440K
High sensitivity, low smear, high anti-blooming.
Auto Electronic Shutter (AES), Auto Gain Control (AGC),
Auto Iris (AI), Back Light Compensation (BLC), Auto White
Balance (AWB), Flickerless mode (FL).
Built-in Vari-focal type DC-drive auto iris lens.
Furnished with power cable and video cable.
Low power consumption.
Easy to install, easy to use, aesthetic.
INSTALLATION INSTRUCTIONS
1.
Please select the most suitable position on the wall or ceiling
to install the camera.
2.
Rotate the dome housing counterclockwise to remove it
from the mounting base (shown on fig. 1).
3.
Set the mounting base onto the wall or ceiling and center it
over the mounting hole, using the two retaining screws for
the main body supplied by the appurtenance bag (shown
on fig. 1).
4.
The unit has a factory installed back conduit entry and one
may adjust the cables to side conduit entry according to
installation requirement (shown on fig. 2).
5.
Once the picture appears on the monitor, open the cover
adjust the lens wrench of "NEAR←→FAR" to get the view
zoom that you desire, then adjust the focus wrench of the
Lens to obtain the best picture. After adjustment, tighten
this two wrench both. (shown on fig. 3).
6.
DIP Switch Setting (shown on fig. 4).
Flickerless Function
Set switch-OFF/ F.L. to Flicker to enable flickerless
function, in this mode, the switch-AES/ OFF is auto
disabled.
AGC-Hi/ AGC-Lo Function
Adjust the switch to AGC indicates AGC-Hi and OFF
indicates AGC-Low. This switch setting to High or Low
of the AGC maximum gain. AGC-Hi mode--The
maximum AGC gain is approximately 26dB. AGC-Lo
mode--The maximum AGC gain is approximately 16dB.
7.
BLC FUNCTION
Set Switch-OFF/ BLC to BLC to enable Back Light
Compensation (BLC) function.
8.
For lens adjustment, move the camera body (some model
types limits the PCB board to180°rotational adjustment)
and set the focus by turning the lens to the left or right
direction. When the camera focus adjustment has been
completed, rotate the dome housing clockwise to secure it
to the mounting base (shown on fig. 5).
9.
Connect the Video Output to the monitor or other video
device through a 75 Ohms type coaxial cable. Connect the
AC/ DC-Terminator with power source (shown on fig. 6).
Note! The inner parts may differ depending on the camera model type
Fig. 1: Remove the dome
Fig. 2: Cable outlet choice
Fig. 3: Adjust the camera lens
Fig. 4: Configure the camera
Mounting Base Dome Housing
or
O R
Zoom Adjustment
NEA R
TE LE
Focal Adjustment
FAR
WIDE