Advertisement
INSTALLATION NOTES:
3. Product Installation
Diagrams
Driver Housing Faceplate
Driver Mounting Tab
Driver
Driver Housing
ARCHITECTURAL & LANDSCAPE LIGHTING
dCrest-
9
|
holmlighting.com
1. Secure the driver housing in-ground in
accordance with local codes and regulations.
2. Connect conduit or cable runs to the bottom of
the driver housing with couplings (1/2"-14 NPT –
provided by others). Use the provided ½"-14
NPT plug for unused conduit openings.
3. Add the installation cover onto the driver
housing with the provided fasteners to prevent
dirt and debris from entering the driver housing.
4. To complete the installation, attach the
luminaire to the driver housing faceplate.
Connect the driver wiring (provided with the
luminaire) to the luminaire using the wiring
diagram and approved wire connectors.
5. Use double-sided tape and a zip tie to secure
the driver to the driver mounting tab.
6. Tighten the 8-32 x ½" set-screw using a 5/64"
Allen wrench to lock the rotational position of
the luminaire to the driver housing faceplate.
7. Seal the driver housing compartment using the
provided gasket and fasteners (10-24 x ½" screw)
with a 1/8" Allen wrench.
Customer Service 1-844-200-4656
2
Advertisement
