Mounting the » air « adapter
Shorten power lines to 6 cm. Strip
cable ends 5–6 mm.
Cable cross-section: 1 –1.5 mm
.
2
Caution!
5–6 mm
Before installation, disconnect
all power cables from the power
1 –1.5 mm
2
supply and note the routing of the
power cables!
Run the power lines through the
opening of the adapter and mark
the positions of the drill holes.
Ensure that the orientation of the
adapter is correct ( see figure ) .
Drill two ø 6 mm holes; insert an-
chors so that they are flush.
40