Table of Contents
Advertisement
Available languages
Available languages
Hereby eQ-3 Entwicklung GmbH, declares that
this device conforms with the essential require-
ments and other relevant regulations of Directive
1999/5/EC.
The full declaration of conformity is provided under
www.HomeMatic.com.
6
Installation and Start up
6.1 Installation
You can fasten the sensor to the desired location
with screws.
In order to access the fastening holes, remove the
cover of the sensor housing.
A neoprene seal is located between the hou-
sing cover and the housing base!
Make sure that this seal is properly seated when
positioning the housing cover again since otherwise
water could infiltrate the housing.
21
Advertisement
Chapters
Table of Contents
