VMAXTANKS BC8S1205A Instruction Manual page 14

13. CHASSIS EARTHING
The chassis earthing lug should be connected to an earting point which will be
depending on where the battery charger is installed. In a vehicle, connect the
chassis ground lug to the chassis of the vehicle. In a boat, connect to the boat's
grounding systems. In a fixed location, connect to earth.
8-STAGE AUTOMATIC CHARGING
P/No.: BC8S1220A
INPUT: 220-240V AC, 50/60Hz, 554W
OUTPUT: 12V DC, 20,000mA
FUSE: T5A, 250V AC
OUTPUT
12V DC
STEP 3 CONNECT TO 110V/220-240V AC MAINS POWER
Connect the battery charger to the 110V/220-240V AC mains powered socket
and turn on the mains power.
STEP 4 CHARGING
During the charge process, the CHARGING and STAGE LAMP will flash various
patterns. This is normal and indicates the various charge stages. Refer to "How
can I know what stage the battery charger is in" in the FAQ section, page 18.
When the STAGE LAMP remains on, this is known as the float stage and the
charger can be left connected to the battery without over charging.
If the POWER ON LAMP is flashing, there is fault; refer to "Fault Codes"
explanation on page 17 of this manual.
STEP 5 DISCONNECTION
Ensure the 110V/220-240V AC mains switch is turned off and the charger is
disconnected from the 110V/220-240V AC mains power.
Battery out of vehicle
Remove the BLACK lead (battery clip) from the battery.
Remove the RED lead (battery clip) from battery.
Battery in vehicle
Remove the chassis connection.
Remove the battery terminal connection.
FAN
INPUT
AC
CHASSIS
GND
13