Installation; Features And Controls; Fcc Statement - Vollrath Mirage Pro 59500P Operator's Manual

INSTALLATION

Clearance and Environment Requirements
NOTICE: This unit is not designed to be enclosed or built into any
area. Sufficient airflow must be allowed around the unit.
Blocking the airflow could cause the unit to overheat.
• Rear of the range to any surrounding surface: 4" (10 cm)
• Bottom of the range to any surrounding surface: ¹⁄₂" (2 cm)
• Indoor use only.
• Do not place the equipment on or near heat-producing equipment.
Installation
NOTICE: This equipment requires a dedicated circuit.
NOTICE: Using a voltage other than the nameplate rated voltage will
cause damage to the unit. Incorrect voltage, modification
to the power cord or electrical components can damage
unit and will void the warranty
1. Place the induction range/warmer on a flat stable surface.
2. Plug the power cord into a grounded electrical outlets that match the
voltage on the rating label.

FCC STATEMENT

This equipment has been tested and found to comply with Part 18 of
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
3. To assure continued compliance, any changes or modifications not
expressly approved by the party Responsible for compliance could
void the user's authority to operate this equipment.
2

FEATURES AND CONTROLS

A B C
A On/Off Button. Press to turn on the range.
B Power/Temp Button. Press to toggle between Power and
Temperature control, and Fahrenheit and Celsius.
C Timer Button. Press to set the timer.
D Display Panel. Displays the power level, set temperature, or time
depending upon the selected mode.
E Timer LED Light. Illuminates when timer function is operating.
F ºC LED Light. Illuminates when the temperature in being
displayed in degrees Centigrade.
G ºF LED Light. Illuminates when the temperature in being
displayed in degrees Fahrenheit.
H Control Knob. Rotate to set temperature, power level or time,
®
Mirage Pro Induction Range Operator's Manual
F G
D E H