Sony WALKMAN NW-WS623 Help Manual page 99

Help Guide
Digital Music Player
NW-WS623/WS625
Replacing the battery of the Remote Commander
(Only for models supplied with the Remote Commander)
Replace the battery of the Remote Commander when the lamp lights up in red. Use a CR1620 Lithium Coin Cell Battery
only.
When you open the battery cover, the water-resistant performance may be impaired by dust, etc. To maintain the water-
resistant performance, consult your nearest Sony dealer or Sony Service Center for replacement of the battery (at an
additional cost).
Make sure that the Remote Commander is turned off. Remove the band (
1
Remove the 4 screws (
2
Open the cover (
3
Check that the packing (
4
Put the cover ( ) back into place and tighten the screws (
5
Do not overtighten the screws (
Reattach the band (
6
Hold down the button (
7
The lamp ( ) will flash. The Remote Commander will turn on.
) using a Size 0 cross-head precision screwdriver.
) and remove the battery. Then, insert a new CR1620 battery with correct polarity.
) is in place and is clean.
).
) back through the loop (
) for 2 seconds.
) firmly to the end.
).
99
) from the loop ( ).