Dust Chute - Chicago Electric 62422 Owner's Manual & Safety Instructions

General Operating Instructions
1. Plug the Power Cord into the nearest
120 volt, grounded, electrical outlet.
2. Position the saw blade of the Jigsaw about
1/2" from the beginning cut line on the
work piece. Do not allow the saw blade
to come in contact with the work piece.
3. Squeeze the Trigger (17) to turn on the
Jigsaw. If operating the Jigsaw for an
extended period of time, press the Trigger
Lock to lock the Trigger in its "ON" position.
See Figure 4, below.
Page 10
Trigger Trigger
(17) Lock
Figure 4
For technical questions, please call 1-888-866-5797.
4. Allow the Saw Blade to stroke at full speed
before slowly feeding it into the work piece.
5. Make sure to hold the Jigsaw firmly
with both hands to avoid kickback.
Then, finish making the cut.

Dust Chute

1. The Jigsaw is supplied with a Dust Chute
adapter for a vacuum. It is attached
to the Dust Chute Connector located
at the back end of the housing.
2. To fasten the Dust Chute (sold separately)
in place, align the pins on Dust Chute with
slots in Connector. Push Dust Chute in and
turn clockwise to lock. See Figure 5, below.
Dust
Connector
Chute
Figure 5
Item 62422