Water Hardness Level Adjustment Table - Blomberg LDV42124 User Manual

Installation
Remove the test Turn on the tap and
strip from the let the water run for
packet. about a minute.
After determining hardness level of the supply water:
1. Turn on the machine, press Time Delay and P+/P keys simultaneously. After the
countdown (3,2,1) is displayed keep the keys pressed for a while.
2. Press P+/P key to activate the (r..) position.
3. Using Time Delay key, adjust water hardness level according to the hardness of
the supply water. See "Water hardness level adjustment table" for correct setting.
4. Press On / Off key to save the setting.

Water hardness level adjustment table

Hardness English Water
Level Hardness °dE
0th Level
0-5
1st Level
6-9
2nd Level
10-15
3rd Level
16-19
4th Level
20-24
5th Level
25-62
If the hardness level of the supply water is above 90 °dF or if you are using well
water, then it is recommended to use water purification devices and special filters.
If the hardness level of the supply water is below 13°dF, there is no need to use salt
in your dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates
continuously on the panel of your machine.
If the water hardness level adjustment is set to level 1, the "No salt warning
indicator" will illuminate continuously although it is not necessary to use salt. If you
use salt under this condition, salt will not be consumed and the Salt indicator will not
illuminate.
14 /45 EN
Hold the test strip in
the water for about
a second.
German Water French Water
Hardness °dH Hardness °dF
0-4 0-8
5-7 9-13
8-12 14-22
13-15 23-27
16-19 28-34
20-50 35-90
Remove the test Wait for 1 minute.
strip from the water
and shake it.
Water Hardness Level Indicator
Press the Time Delay key to switch the water hardness level
to position 1. (r1)
Press the Time Delay key to switch the water hardness level
to position 2. (r2)
Press the Time Delay key to switch the water hardness level
to position 3. (r3)
Press the Time Delay key to switch the water hardness level
to position 4. (r4)
Press the Time Delay key to switch the water hardness level
to position 5. (r5)
The test strip shows
you the hardness
level.
Dishwasher / User manual