Lindy 38170 User Manual page 4

User Manual
Installation
Please follow the steps below for installation.
1. Connect the HDMI Source device to the transmitter directly.
2. Remove the pre-installed dust covers from the LC fibre optic
ports on the TX and RX units. Carefully connect a duplex LC
OM3 multi-mode fibre optic cable to the ports on the TX and
RX units, ensuring that the fibre connection is crossed as
shown.
3. Connect the receiver to an HDMI display or projector directly.
4. Ensure both the transmitter and receiver are connected to
either a 5V1A USB charger or USB 3.0 port using the two
USB Type A to Micro-B cables.
5. Power on the source and display devices, followed by the
transmitter and receiver units.
This completes the installation.
Troubleshooting
If the display is not showing an image as expected after installation, please consider the following steps to
resolve the issue.
•
Check that all cables are firmly secure in their ports, including the Micro-B power cables, HDMI
connections and fibre optic cable.
•
This extender requires the duplex fibre optic connection to be crossed between the transmitter and
receiver units. Please check that both strands of the fibre optic cable are connected to the opposite
ports. Please see the diagram above for further information.
•
For HDMI devices, it may be helpful to unplug and re-plug their HDMI connection to re-initiate the
HDMI handshake and recognition.
•
Power off all devices, then power each device back on in the following order: first the transmitter, then
the receiver, followed by the display or projector and finally the source device.
•
Check the output resolution and colour depth. If this is greater than the maximum supported resolution,
reduce the output resolution.
•
Check the length of the duplex LC OM3 multi-mode fibre optic cable used, if this is greater than 300m
(984.24ft) please reduce this length.
English