Haas+Sohn Exquisit 182.18-AL Instructions

Complete product information,
Installation of the combustion chamber liner:
Note: Labels with the short designations are attached to the mounting parts.
1. Install first row: first (A) (rear block centre) (top groove rearward), then rear blocks (B) left and right (top
groove rearward)
2. Insert bottom blocks (F, G and H).
3. Insert ash pan (5) and grate (9).
4. Install second row: rear blocks (A) and lateral blocks (B,I,J).
5. Instell front blocks(K,L,M)
5. Insert insulating block (16) and draught deflector plate (10).
Installation of the insulating block: Insert insulating block (16) with the short edge into the upper sheet steel
groove (see drawing) and let slip into the lower sheet steel groove.
Installation of the draught deflector plate: Insert draught deflector plate (10) slantwise (bevelled corners at
the back) and place it on the lateral sheet steel angles, then lift the front edge and place it on the support plate.
Important: Push the draught deflector plate to the front until the limit stop is reached!
Important: After cleaning of the appliance, or before returning it to service, checks must be carried out to
ensure that the baffle plates are in the correct position (see diagram).
Suitable fuels:
The following fuels are permitted for use in your wood burning stove (see also section 5.1):
Dry, well seasoned, unadulterated wood and wood briquettes which comply with DIN 51731
„
HAAS+SOHN Exquisit 182.18-AL"
Product number 0618218010000
No. Product no.
1
2 0618218015300
3
4
5 0618018005600
6 0618018015002
7 0089000020000
8
9 0020100130005
10 0050500070005
11 0618218010001
12 0081220020005
13 0081220040005
14 0618218015301
15 0088400060000
16 0050500060000
17 0087255300095
18 0088500050005
19
1
Product number. 0618218019030
V09 G07
Description
Body of the stove
Door to the combustion
chamber
Refractory
Wood storage compartment
Ashpan
Supports for the exhaust flue
Adjustable feet
Secondary air
Grate 260x152
Plate for diverting the
exhaust Glases
angled upwards
Air intake control
Fitting for the door handle
Door handle (for the door to
the combustion chamber)
Inspection window
Door spring
Insulating brick
Door latch
Socket for the pipe supplying
air from outside Ø 100
Air duct