Related Manuals for Human Touch ZeroG 5.0
Summary of Contents for Human Touch ZeroG 5.0
-
Page 2: Getting Started
Getting Started 1) Verify that the chair has not been used for more than three consecutive cycles. If it has, power off the chair for 30 minutes to allow the chair to cool down. NOTE: If you run the chair continuously for more than three massage cycles, it may shut down to protect the chair from overheating. - Page 3 What’s not working What are the symptoms? Here’s what to do: properly? The remote is not Replace the remote. Remote Control working at all. One function on the The problem is likely the function remote is not working. you are trying to use. See that function elsewhere in this table.
- Page 4 What’s not working What are the symptoms? Here’s what to do: properly? recline or incline. at least five seconds; it can take several seconds to activate. 2) If the problem remains, replace the backrest actuator. 3) If the problem remains, replace the chair.
- Page 5 Power 1) Check the power cord. Make sure the power cord connection to the chair’s power panel is secure and that the power cord is not damaged. If the cord is damaged, replace the power panel. 3) Check the wall outlet. Plug a known working device into the outlet.
Need help?
Do you have a question about the ZeroG 5.0 and is the answer not in the manual?
Questions and answers
I can’t not get the intensity to change on my remote
You can adjust the intensity of the 3D rollers independently for the neck and lower back. If you want more intensity in the neck, adjust the rollers in that area. If you want more intensity in the lower back, adjust the rollers forward or back in that area. This allows you to customize the massage intensity separately for each section.
This answer is automatically generated