Advertisement
Quick Links
Advertisement
Related Manuals for Gate Easy STD 56-272 Easy STD 56-273
Summary of Contents for Gate Easy STD 56-272 Easy STD 56-273
- Page 1 Instructions for use Easy STD Hygiene chair Easy STD 56-272 Easy STD/Wheel and hand rim 56-273...
- Page 2 Congratulations on obtaining a Bure Walker! These instructions provide important information on how to use the walker and how to maintain it. 1. Uttag för batterikontakt All of us here at GATE Rehab Development hope you enjoy using your new product. 2. Uttag för stickpropp Laddning av batteri If you have any comments, questions or points of view, please contact us on: (OBS! För att IP-klassning ska gälla så...
-
Page 3: Height Adjustment
Height adjustment EASY has a simple height adjustment mechanism. The mechanism consists of toggle locks on either side. The locks have two positions – open and locked. <OPEN> <LOCKED> Övriga instruktioner • • • To change seat height: Kopplingsschema Styrbox Laddning Batteri 1) Flip the toggle locks to the <Open>... - Page 4 Foot support / heel restraint a) The foot support can be adjusted in height by removing the clips (see figure 6) and moving the foot support to the desired height (make sure to replace the clips). b) The foot support can be swung to the side by grasping it at arrow B and lifting/swinging.
- Page 5 Sanitary pan The sanitary pan is slid into position from behind between the seat and wire guides as shown in figure 8-9. Make sure the sanitary pan is slid into position above the wire guides. Also make sure that the pan is in the right position in relation to the seat/ cut-out.
- Page 6 Installing/removing the seat Installing seat with the rear opening (accessory) The seat comprises two halves that are snapped in place with the aid of clamps on the seat’s underside. Locking the armrests (accessory) The armrest is locked in the extended position. To lift the armrest, pull out the pin (1) and raise the armrest (2).
- Page 7 Wheel and hand rim 22” (accessory) Bild från sidan med drivhjul och broms monterad 125 mm The wheel and hand rim kit consists of wheel attachments (two pairs) with a QR axle (one pair) and parking brakes with aluminium attachments (one pair) Tools required for installation (not included in the kit): Allen key (4 mm) and an adjustable wrench (10”).
-
Page 8: Maintenance
6. Height adjustment mechanism – check that the seat can be locked on both sides regardless of height. Would you like to know more? Contact us at: Tel: +46 371 31800 Gate Rehab Development AB Industrigatan 2 | SE-330 21 Reftele info@gaterd.se | www.gaterd.se YOUR HEALTHCARE PARTNER...