Advertisement
3
Fill the kettle with water to the
desired level on the Gauge (3)
ensuring that it is above the
MIN mark and below the MAX
mark.
•
4
5
Insert the mains plug (with dry hands) into the
mains socket.
Push the Switch (8) down and the blue internal
LED's will illuminate and the water will begin to
boil.
At the end of the boiling cycle the Switch (8) will
automatically switch off and the LED's will go out.
Wait until the water has finished boiling before
removing it from the Base.
•
Boil dry protection
Should you accidentally let the appliance operate without water; the boil-
dry protection will automatically switch off the power. If this occurs, allow
the appliance to cool and reset before use.
Lime scale removal
• To maintain the performance of your kettle it is recommended you descale
it once every three months to increase the life expectancy and reduce lime
Push the Lid (2) until it clicks fully
closed and then place the kettle onto
the Base (7).
•
5
Advertisement
