Advertisement
Assembly
1.) Bolt the large castor wheels (9) to the rear-most mountings on the main frame and to the legs
using M8x20 bolts (4), M8 washers (3), M8 lock washers (2) and M8 nuts (1). Bolt the small
castor wheels (14) to the forward mountings on the main frame using M8x14 bolts (10), M8
washers (3), M8 lock washers (2) and M8 nuts (1).
2.)
Assemble the legs to the frame using the 16x110 pins (11). Lay each leg into the open
channel and insert the first pin into the hole nearest the rear of the frame. This will be the
foldering leg pivot. Retain the pin with a "R" clip (15). Lock the leg in the down position by in-
serting a second 16x110 pin (11) into the hole nearest the open end of the channel and retain
with a "R" clip (15).
3.)
Bolt the main upright to the cross member between the open channel using two
M14x100mm bolts (8), M14 washers (7), M14 lock washers (6) and M14 nuts (5). Do not fully
tighten the nuts at this stage.
4.)
Take the two support struts and loosely bolt them to the top of the main upright using a
M14x100 bolt (8). Insert two M14 bolts (8) through the angled parts of the main base in the
holes adjacent to the rear square section ensuring that the bolt heads are on the outside of the
frame. Slide the bottom of each support strut over the end of each bolt in turn and secure with
the nuts and washers provided. Fully tighten all the nuts and bolts holding the main upright
and stuts.
5.)
Take the engine mounting plate and insert it through the tube at the top of the main
upright. Rotate the plate until one of the holes in the inner tube is aligned with a hole in the
outer tube and insert the locking pin (13).
6.)
Take the handle and insert it into the hole in the part of turning plate tube protruding
through the top of the main upright.
7.)
Attach the adjustable mountings to the turning plate using M14x60 bolts (12), M14
washers (7), M14 lock washers (6) and M14 nuts (5).
8.)
To fold up the legs remove the "R" clips (15) from the 16x110 pins (11) furthest from
the rear of the frame and pull out the pins. Fold the legs up. Always retain the legs in the up-
right position by re-inserting the pins (11) through the holes in the frame directly in front of the
folded legs. Retain the pins (11) with the "R" clips (15).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Version 5.2017
Seite 5
Advertisement
