Safety Signs & Decals; Safety Decals - CRT 5050-5050GS Operator's Manual

LOCK-IN WHEELS
Never start or operate tiller with wheels in the
Free-Wheel position. Make sure wheel lockouts
are engaged through wheel hubs and axle.
To operate, tiller wheels must be kicked in.
Disengage wheel lockouts ONLY when engine
is stopped.
OPERATION
REFER TO OPERATORS MANUAL
FOR DETAILED OPERATING INSTRUCTIONS
TO START:
Release drive control levers to neutral position.
Lower the drag bar so that tines do not touch
the ground.
Check position of wheels and wheel lockouts.
Slide choke mond to choke position.
Move throttle control lever to fast position.
Pull starter rope.
LEILCRTA
AVOID SERIOUS INJURY OR DEATH
Read operators manual(s).
Know the location and function of all controls.
Keep all shields and guards in place and
working while running.
Never operate tiller when children are around.
Dress appropriately -- wear sturdy footwear.
Carefully inspect area to be tilled — remove
large rocks and other foreign objects.
Do NOT till above underground electric, water,
gas, or other utility fires and pipes.
STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE before removing debris
or servicing unit.
When leaving the operating position
for any reason:
— shut off the engine.
— wait for all moving parts to stop.
A
DANGER
AVOID INJURY FROM
ROTATING TINES!
Keep hands, feet,
and clothing away.
Tines rotate when filler is
engaged in forward or reverse.
Tines and wheels rotate when
drive control levers are pulled
down.
In reverse, tines and wheels
rotate when the reverse handle is
pulled back toward the operator.
Releasing the drive control
levers to neutral steps the
wheels and tines.
Le.,5,6c
Part No. LBL821B
WARNING / Hood Decal
Part No. LBLCRTA
OPERATING INSTRUCTIONS /
Hood Decal
SAFETY SIGNS & DECALS
SAFETY DECALS
Safety warning decals are placed at strategic locations on the equipment as a constant reminder to the operator
of the most important precautions. All warning, caution and instructional messages on your equipment should be
carefully read and obeyed. If any of these decals are lost or damaged. replace them at once. They can be
purchased from Ardisam, Inc.
Part No. LBL516E
TINES DANGER / Hood Flap Decal
DO NOT START ENGINE UNLESS BELT
COVER IS ATTACHED. KEEP HANDS. FEET.
AND CLOTHING AWAY FROM MOVING BELTS
AND PULLEYS. FAILURE TO COMPLY COULD
RESULT IN INJURY SEE OWNER'S MANUAL
FOR FULL SAFETY INSTRUCTIONS.
Part No. LBL516C
WARNING / Belt Cover Decal
Part No. LBL516F
FREE HAND / Bumper Guard Decal
5