Cisco 350 Series Quick Start Manual page 10

If this is the first time that you have logged on with the default
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
Enter Y, and set a new administrator password.
S 5
TEP
Password complexity is enabled by default. The password
N
OTE
must comply with the default complexity rules.
Make sure that any configuration changes made are saved
C
AUTION
before exiting.
You are now ready to configure the switch. Refer to
350switches to locate the CLI Guide for your switch.
If you are not using DHCP on your network, set the IP address type
N
OTE
on the switch to Static and change the static IP address and subnet mask
to match your network topology. Failure to do so may result in multiple
switches using the same factory default IP address of 192.168.1.254.
10
www.cisco.com/go/
Cisco 350 Series Managed Switches