Diagram; Using The Usb Port; Using Led Flash Light - Walmart EverStart Manual

attempts. If Jump Starter becomes warm, disconnect Jump Starter from the
cables and allow to cool before reattempting to start the vehicle.
After successfully starting the vehicle, always remove the clamp cable's blue plug from
3
the jump starter first, then disconnect the clamps from the car battery terminals.
When the LED indicator of the clamps is green, DO NOT disconnect the clamps
4
from the car battery terminals before removing the clamp cable's blue plug from the
jump starter.

DIAGRAM:

①
Red clamp connect "+",
Black clamp connect "-"
③
Start the vehicle
⑤
Remove the clamps from the battery

USING THE USB PORT

1. Make sure the AC charging adapter and 12V DC charger is disconnected.
2. Plug the USB-powered device into the USB port.
3. Press the power button one time to turn the power on. The LED power indicator turn light to
indicate the unit's internal battery status.
4. The LED power indicator will turn off after 5 seconds, while the USB output continues.
5. After charging is complete, disconnect the device from the USB port.
port will turn off automatically after 30 seconds.

USING LED FLASH LIGHT

1. Press the power button to turn the unit on.
2. Press again to change between light & flash.
3. Double press the power button quickly to turn off the light.
②
connecting the jump cable
to the jump starter
④
Disconnect the jump cable from
Jump starter first
Power to the USB