Related Manuals for Walmart EverStart
Summary of Contents for Walmart EverStart
- Page 1 MULTI-FUNCTION JUMP STARTER FEATURES 1. Flashlight 2. Jump Start Port 3. LED Power indicator 4. USB Output 5. Power button 6. Charging port 7. Car battery clamp 8. Home charger&Car charger 9. Portable bag...
- Page 2 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
- Page 3 supplied AC charging adapter for a full 6 hours(or until the unit shows as fully charged)before using for the first time. The recommended method for recharging this unit is using the AC charging adapter. When using this method, only use the AC charging adapter supplied with the unit. Plug in the charging adapter at the jump starter first, then plug into the charging source.
- Page 4 Always charge at least every 3-6 months to prevent over discharge. Transportation of Lithium-Ion Batteries Always check all applicable local, national, and international regulations before transporting a unit containing a lithium-ion battery. Transporting an end-of-life, damaged, or recalled battery may, in certain cases, be specifically limited or prohibited.
- Page 5 Power status 2 red LEDs 4 red LEDs 4 red LEDs+2 blue LEDs 4 red LEDs+4 blue LEDs 100% All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. Recharge the unit every 3-6 months if not in use, or when the power is insufficient. CHARGING/RECHARGING THE UNIT Lithium batteries require routine maintenance to ensure a full charge and long battery life.
- Page 6 USING THE 12V DC CHARGER WARNING: TO AVOID THE RISK OF PROPERTY DAMAGE: Recharge using this method only when necessary. Do not leave the unit unattended when charging using 12V DC charger. 1. Insert the barrel connector of the 12V DC charger into the unit’s charging port. 2.
- Page 7 attempts. If Jump Starter becomes warm, disconnect Jump Starter from the cables and allow to cool before reattempting to start the vehicle. After successfully starting the vehicle, always remove the clamp cable’s blue plug from the jump starter first, then disconnect the clamps from the car battery terminals. When the LED indicator of the clamps is green, DO NOT disconnect the clamps from the car battery terminals before removing the clamp cable’s blue plug from the jump starter.
- Page 8 ONE-YEAR LIMITED WARRANTY Walmart guarantees this product to the original purchaser for a period of ONE YEAR against any defects in material and workmanship, but shall not cover damage caused by misuse, abuse, alteration, accident, and failure to follow instructions for care and maintenance for the product.
Need help?
Do you have a question about the EverStart and is the answer not in the manual?
Questions and answers
get an error code "8" when trying to charge my battery?
The scrolling number "8" on the EverStart Plus Smart Charger is not an error code. It is likely the charger's default display during startup or when it is trying to detect the battery. This may happen when the battery is too deeply discharged for the charger to recognize or begin charging.
This answer is automatically generated