Mounting Onto An Over-Head Cross-Beam Example - Symbol VC5090 Product Reference Manual

2 - 6 VC5090 Vehicle Computer Product Reference Guide
Important Fixing Information
CAUTION
A minimum of four fixing positions must be used.
•
All nuts and caps screws must be checked periodically and tightened if required.
•
When installing the vehicle computer, care must be taken to ensure that the mounting bracket footprint is
•
fully supported. Additional plates may be required to achieve this.

Mounting onto an Over-Head Cross-Beam Example

The diagram below illustrates a typical installation where the vehicle computer is mounted onto a cross-beam.
Lock Washers
Flat Washers
Flat Washers
Lock Washers
Cap Screws
Mounting the VC5090 onto an Over-Head Cross-Beam Example
Figure 2-6
Any modification to supplied mounting bracket could cause failure of the unit and/or mountings.
Nuts
Vehicle Cross-Beam
Mounting Bracket