Symbol MC9000-G Product Reference Manual page 155

Reader
Parameters Imager Values
Reader Type Imager
Aim Type Trigger, Timed hold, Timed
release
Aim Duration 0-60,000 ms
Aim Mode Dot, Slab, Reticle, None
Beam Timer 0-60,000 ms
Pointer Timer 0-60,000 in increments of
100ms
Image Capture 0-60,000 in increments of
Timeout 100ms
Image Compress 0-60,000 in increments of
Timeout 100ms
Linear Sec All codes *2,
All Codes *3
Long*2, Short*3
Short, Redun
Short, Codabar
Focus Mode Fixed, Auto, Smart
Focus Position Far, Near
Table 3-9. Imager Reader Parameters
Imager type scan engine is used.
Trigger mode: On/off controlled by the trigger.
Trigger hold mode: Trigger can be released but it remains active for
the specified period of time.
Timed release mode: Activation stops after a specified period of time,
even if the trigger is held.
Sets the Aim Duration time duration (0-60,000 ms in increments of
100 ms).
Use only None (no aiming) or Reticle (reticle aiming).
Sets the maximum amount of time that the laser remains on (0-60,000
ms in increments of 100 ms). A value of 0 sets the laser to stay on.
Pointer Timer is not supported.
Image Capture Timeout is not supported.
Image Compress Timeout is not supported.
Sets the number of times a barcode is re-read to confirm an accurate
decode.
All codes *2 : Two times read redundancy for all bar codes.
All codes *3 : Three times read redundancy for all bar codes.
Long *2 Short *3: Two times read redundancy for long bar codes,
three times for short bar codes.
Short, Redun: Two times read redundancy based on redundancy flags
and code length.
Short, Codabar: Two times read redundancy if short bar code or
CODABAR).
Fixed mode is the only focus mode supported.
Specifies the Fixed setting, focus position for Far is 9 inches and focus
position for Near is 5 inches.
Description
3-61
Settings