CHANGE ACCESS CODE
To change access code, follow the steps.
1
Select "V-CHIP SET UP"
Press the MENU button on the remote control.
Press the PLAY/K or STOP/L button to select "V-
CHIP SET UP".
Then, press the F.FWD/B button.
2
Enter Access code
Use the number on the remote con-
trol to enter the access code.
The default code is 0000.
3
Select "CHANGE CODE"
Press the PLAY/K or STOP/L but-
ton to select "CHANGE CODE".
Then, press the F.FWD/B button.
This TV/VCR will operate with any cassette that has the
recommend the use of high-quality tapes. Do not use poor quality or damaged tapes.
PRECAUTIONS
•
Avoid moisture. Moisture condensation may occur
on the tape if it is moved from a cold place to a
warm place or visa versa. Before using a tape with
these conditions, to avoid damage of the tape and
your TV/VCR, wait until the tape has warmed to
room temperature and the moisture has evaporated.
•
Avoid extreme heat, high humidity and magnetic
fields.
•
Do not tamper with the cassette mechanism.
•
Do not touch the tape with your fingers.
NORMAL PLAYBACK
Make sure ...
•
TV/VCR power must be turned on.
1
Insert a prerecorded tape
If the erase-protection tab has been removed, the
TV/VCR will start playback automatically.
2
To begin playback
Press the PLAY button.
Note: If any menu is activated on
the screen, the PLAY button does
not function. Press the MENU but-
ton to clear the menu. then, press
the PLAY button.
3
To stop playback
Press the STOP button when play-
back is completed.
4
Use the number buttons to enter
your desired access code in the
NEW CODE space. Then enter the
same code in the CONFIRM
CODE space. V-CHIP SET UP
screen appear on the screen.
•
If you enter wrong code, repeat step 4, making sure
you enter the same new code exactly in the confirm
code space.
ACCESS CODE
5
_ _ _ _
Exit the V-Chip setting mode
Press the MENU button on the remote control to exit
the screen.
Note: If you unplug the power code or power failure
– V-CHIP SET UP –
occurs, the changed access code will be lost and will
TV RATING
MPAA RATING
return to default (0000). Change your access code
B CHANGE CODE
again as necessary.
PLAYBACK
INSERTING A CASSETTE
Insert the cassette in the direction as shown. Push in
gently, but continuously, on the center-back of the
cassette until it is drawn into the TV/VCR. The
TV/VCR will automatically turn on.
Window
The TV/VCR has the auto repeat function that allows
you to repeat a tape indefinitely without touching the
PLAY button.
ALL REPEAT:
to the end of the tape.
BLANK REPEAT
ning to a blank part, which is blank for more than
10 seconds.
PLAY B
1
Press the MENU button on the
remote control.
Press the PLAY/K or STOP/L but-
ton to point to "USER'S SET UP".
STOP
Then, press the F.FWD/B button.
- 17 -
Enter New code
mark. For best results, we
CORRECT
AUTO REPEAT PLAYBACK
Repeat playback from the beginning
: Repeat playback from the begin-
Select "USER'S SET UP"
NEW CODE
X X X X
CONFIRM CODE
_ _ _ _
WRONG
– M E N U –
TIMER PROGRAMMING
PICTURE CONTROL
SETTING CLOCK
CHANNEL SET UP
B USER'S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
EN
1K09