Safety; Drill Column - Husqvarna DS250 Series Operator's Manual

• The model DS150 can be used with drill bits with a
maximum diameter of 150 mm.
• The product is made of aluminum which makes it
light in weight. It has a built-in vacuum plate for
stable operation.
• The DS250 models can be used with drill bits with a
maximum diameter of 250 mm.
• The drill column can be tilted 0–60°.
• The DS250 models have a quick mounting plate for
the drill motor. On model DS150 the drill motor is
installed on a collar.
• A vacuum pump is available as an accessory for all
models.
Intended use
This product is used together with a Husqvarna drill
motor to drill in ceilings, walls and floors. The product is
used on concrete, brick and different stone materials. All
other use is incorrect.
The product is used in industrial operations by operators
with experience.
Symbols on the product
WARNING: This product can be dangerous
and cause serious injury or death to the
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING: Used if there is a risk of injury or
death for the operator or bystanders if the
instructions in the manual are not obeyed.
CAUTION: Used if there is a risk of damage
to the product, other materials or the
adjacent area if the instructions in the
manual are not obeyed.
Note: Used to give more information that is necessary in
a given situation.
Always use common sense
WARNING: Under no circumstances should
you modify the original design of the
machine without approval from the
manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
1341 - 002 - 24.10.2019
operator or others. Be careful and use the
product correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use the product.
Use approved hearing protection.
Note: Other symbols/decals on the product refer to
special certification requirements for some markets.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.

Safety

It is not possible to cover every conceivable situation
you can face when using a drilling machine. Always
exercise care and use your common sense. Avoid all
situations which you consider to be beyond your
capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing.
Do not hesitate to contact your dealer if you have any
more questions about the use of the machine. We will
willingly be of service and provide you with advice as
well as help you to use your machine both efficiently and
safely.
Let your Husqvarna dealer check the drilling machine
regularly and make essential adjustments and repairs.
All information and all data in the operator's manual
were applicable at the time the operator's manual was
sent to print.
General safety instructions
WARNING: Read the warning instructions
that follow before you use the product.
• This product is a dangerous tool if you are not
careful or if you use the product incorrectly. This
product can cause serious injury or death to the
3