Table of Contents
Advertisement
7
© 2018 JTECH Medical MN002_AD
Tracker Freedom System Setup
Initial Battery Charge
Performing the required initial charge for your new instrument batteries is essential before
attempting to use them . After initial charging is complete, we recommend you contact JTECH
Medical to complete the software installation and setup .
Tracker Freedom instruments should not be used for testing while
Warning:
connected to the charger .
The specified power supply is used to isolate the device from the mains supply
Notice:
during charging .
Use only a factory-supplied charger . Use of another charger may result in
Warning:
electrical shock or equipment damage .
Instrument batteries must be fully charged before attempting to use them with
Notice:
your Tracker Freedom System . Each instrument must charge for at least six (6) continuous
hours before its first use . Do not use more than one daisy chain with each power supply as
it will affect the charge strength . Do not charge more than four (4) devices at a time .
Charging Instrument Batteries
1 . Plug one battery charger daisy chain plug into the instrument charging jack . You can
charge up to four instruments at a time . Place the instrument on a flat surface or back
in the case while it charges .
2 . Plug the battery charger into a properly rated wall outlet . Batteries should be charged
for six (6) continuous hours each time you charge .
3 . Once an instrument is charged, disconnect it from the battery charger to avoid
damage to the battery .
4 . Charge all instruments with your system before establishing communications with
your computer .
Be careful not to drop instruments while connected to the charger as it may
Notice:
cause damage to the instrument .
Before using your Tracker Freedom system with Tracker software, additional software setup
is required . Please consult your Software User Guide for specific software related setup
instructions .
Detachable parts
Specified Power Supply (Battery Charger) (PW005) – The
Specified Power Supply (Battery Charger) is used individually, or
with the Daisy Chain, for charging your Tracker Freedom devices .
Daisy Chain (8WR008) – The Daisy Chain is used to charge up to
four (4) Tracker Freedom devices at once .
Advertisement
Table of Contents
