C Preparation For Use; Antenna/Cable Connection - Sylvania 6719DE Owner's Manual

45.
SELECT Button
Press to switch TV/VCR and DVD mode. You
can see the mode (TV/VCR or DVD) on the front
panel indicator.
46.
ANT. in Jack
Connect to an antenna, cable system, or satellite
system.
Satellite Box or
Cable Box (Not supplied)
O UT
75-ohm
From Cable Coaxial
System Cable
(Not sup-
plied)
75-ohm Coaxial
Cable (Not
supplied)
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor
antenna.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to your unit without a converter box.
By using this connection you can:
1) Use the unit's remote to select channels.
2) Program one or more unscrambled channels for
Automatic Timer Recording.
NOTE: This unit will ONLY record and view the
same channel.
PREPARATION FOR USE

ANTENNA/CABLE CONNECTION

From Cable System or
IN
Satellite Dish
AUDIO OUT
ANT.
COAXIAL
ANT.
or
47.
Power cord
Connect to a standard AC outlet (120V/60Hz).
Remove the power cord from the hook to
NOTE:
avoid breaking a wire before you connect
to a standard AC outlet.
48.
COAXIAL digital audio out Jack
Connect to the digital input of an external
amplifier or decoder (for DVD audio only).
or
VHF/UHF
Combiner
(Not supplied)
or
CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown in the illustration.
By using this connection you can also record scram-
bled channels. However, channel selection must be
made with the converter box or satellite box. This
means that channels cannot be changed using the
unit's remote control. Unattended timer recording is
limited to one channel at a time.
- 11 -
VHF/UHF Antenna
(Not supplied)
VHF Antenna (Not supplied)
UHF Antenna
(Not supplied)
[Fig. 4]
Flat twin-lead cable
Antenna/Cable Connections
Continued on the Next Page.
EN
1C29