Installation - AEG AGN2291 User Manual

42 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

7. INSTALLATION

WARNING!
Refer to Safety chapters.
7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
Possible cause
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The temperature regulator
is not set correctly.
The food products' temper-
ature is too high.
The FROSTMATIC function
is switched on.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
Solution
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Refer to "FROSTMATIC func-
tion".
Climate Ambient temperature
class
ST +16°C to + 38°C
T +16°C to + 43°C
7.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the