Tools Needed; Hardware Provided - Koala Kare KB110-SSWM Installation And Operation Instructions For

KB110-SSWM
Please Note: To assure proper installation, it is suggested that a qualified person or carpenter install the
Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed
properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended total
weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight may cause
a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible "click". Straps can be adjusted to
make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station should be inspected on a daily basis and parts replaced if they
do not pass inspection criteria.
• Has a pneumatic shock that controls the smooth opening and closing of the unit. Shock may need
replacement if door opens or closes too rapidly or door doesn't close completely.
• Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit
at both ends.
• Has a warning label affixed to the product.
• Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
• Provides a clean changing surface for customers to attend to their children.
Visit koalabear.com to view list of replacement parts and videos.
gloves
1/8" (3 mm)
(regular masonry)
&
drill bits
Operating Instructions

Tools Needed

drill pencil
Phillips head
screwdriver

Hardware Provided

four ¼"x 3" (6 mm x 76 mm)
Phillips panhead wood screws
measuring
stud finder
tape
7/32" (6 mm)
(regular masonry)
&
drill bits
level
½" (13 mm)
(regular masonry)
&
drill bits
four ¼" (6 mm)
flat washers