Required Tools And Equipment - Cisco 6160 Hardware Installation Manual

Required Tools and Equipment

2.3 Required Tools and Equipment
Table 2-4
Table 2-4
Check
Cisco 6160 Hardware Installation Guide
2-16
lists the tools and equipment you need to install and connect the Cisco 6160 system.
Tool and Equipment Requirements Checklist
Tools and Equipment
Hardware Components and Cables
Cisco 6160 chassis, which will have the following components already installed:
Line cards (one or more types):
•
8xIDSL.
–
– 8xG.SHDSL.
– 8xDMT.
– 4xSDSL.
– 4xflexi.
One of the following NI-2 cards:
•
DS3+T1/E1 IMA.
–
DS3/2DS3.
–
OC-3c/2DS3 SMF
–
OC-3c/OC-3c SMF or MMF.
–
One of the following I/O cards:
•
DS3/2DS3+8xT1 I/O card.
–
DS3/2DS3 I/O card.
–
The I/O card should ship with an EMI cover, screws, standoff screws, and washers.
Note
• PEM(s).
• Blower tray.
Blank faceplates, as necessary.
•
Third-party POTS splitters can be installed in a Cisco 6160 with a POTS splitter
configuration. Please verify the compatibility with your Cisco representative.
Telco cables with Champs connectors for the following configurations:
Cisco 6160 with a POTS splitter configuration.
•
Cisco 6160 to third-party POTS splitter connections.
–
Third-party POTS splitter to MDF
–
Cisco 6160 without POTS splitter connections.
•
– Cisco 6160 to MDF.
Note See Appendix B, "Cable and Port Mapping Specifications"
for the subscriber connections. Refer to the third-party POTS splitter documentation
for cable specifics.
1 2
or MMF .
3
connections.
Chapter 2 Preparing for Installation
for a port mapping table
OL-2190-02 B0