Oliveri Rome Dual Shower Installation Instructions

THIS DUAL SHOWER MUST BE INSTALLED BY A LICENSED PLUMBER IN
ACCORDANCE WITH LOCAL REGULATIONS
This Oliveri dual shower is manufactured to standard AS/NZS 3662.
MAX OPERATING PRESSURE: ..............................................................5 bar (500kPa)
RECOMMENDED OPERATION PRESSURE: ..........................................1.5-5 bar (150-500kPa)
MAX HOT WATER TEMPERATURE: .....................................................65°C
RECOMMENDED HOT WATER TEMPERATURE: ..................................50°
Where water pressure exceeds 500kPa, a pressure reducing device is required to be installed. Note that
water pressure overnight can reach 150% of the daytime pressure.
Before attempting any work involving mains water supply lines, ensure the water supply is shut off.
This dual shower must be installed in accordance with these instructions.
Issue Date 05/12/2018 Revision Number:V1:1
RO36341CR
Rome Dual Shower set CP
CARE & MAINTENANCE
Clean with a soft cloth and warm soapy water as necessary - rinse and dry after cleaning. Under no circumstances
should abrasive or acid based cleaning products be used.
WARRANTY
This dual shower is warranted to be free from manufacturing defects for a period of 15 years: 15 years for main body,
2 years for plastic hand piece and shower rail, wall bracket, hose, seals, o'rings. 1 year for finish and labour.
This warranty does not cover against normal wear and will be voided if the product is misused or not
installed in accordance with these instructions.
In the event this product is rendered obsolete and a replacement product is required, Oliveri Solutions Pty Ltd
reserves the right to supply a product of equal substitution at their discretion.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
SERVICE
If the product represents a danger, or damage to property may occur, immediately shut off the water supply.
If the product requires servicing, please contact your installer (preferably the one who installed it).
If the installer is satisfied that the problem is not due to poor installation, contact T2 Services Pty Ltd for
assistance on:
Ph: (07) 55960738
Fax: (07) 55273353
Email: oliveri@t2services.com.au
http://oliveri.com.au/services-and-warranty
If a warranty service agent finds that the shower is not at fault, T2 Services Pty Ltd reserves the right to pass
on any callout fee to the householder.
RO36341CR installation instructions.pdf