Table of Contents
Advertisement
www.PyleUSA.com
5: LOADING NEGATIVES
Hold up the negative toward the light. As you look through
the negative you should be able to read the small negative
numbers normally (not a mirror image). Now turn the
negative so the image is upside down while looking at the
same side.
Open the negative holder at the marked spot on the top. With the negative
holder laid open place the negative into holder so the notches line up with the
notches on the holder.
Note: Handle negatives with care. Any dust, scratches or
ngerprints will show up on your saved images. If possible
use cotton gloves when handling negatives.
It is recommended to use compressed air to remove any
dust on the negatives. This is not included with the lm & photo scanner but
can be purchased from an o ce supply or electronics retailer.
Close the negative holder and press the edges so that it locks in place
Hold it in the position as shown in the lm & photo scanner.
Insert the negative holder into the slot on the right side of
the lm & photo scanner as shown.
Film Holder:
The design of the lm holder follows ISO standard. In some cases the holes on
the lm will not match exactly to the alignment of the holder. This is caused by
a non-standard camera. In this case there will be a small black line on the edge
of the frame that can easily be cropped out using photo editing software.
6
Advertisement
Table of Contents
