Advertisement
4-1. Setup Menu (BVP-500 series)
4-1-1. Operation Menu
Page
Ver.
Item
Gain SW
Low
Middle
High
Wide Screen
16:9/4:3 Mode
(For OHB-405WS
/500WS series)
VF Aspect
4:3 Safety
16:9 ID On VF
16:9 ID
On Bars
MON Out
BNC Test Out
RM/MON CHAR [On], Off
VBS Lock
VF Video
Mode
[RGB]-G
a)
In the 16:9 mode, the following kinds of safety zone marker can be selected in combination of the settings of "Safety Zone" and
"4:3 Safety".
4:3
Safety
On
Off
b)
The change of aspect ratio using this menu is disabled because the CCU' s setting has a priority when the CCU is connected.
If you want to change the aspect ratio when the CCU is connected, use the Others page of the Paint menu. When you attempt to
change using this menu, a message "Use Paint MNU" is displayed.
4-4 (E)
Settings
_3,[0], 3, 6, 9, 12,
18, 24, 30 dB
_3, 0, 3, 6, [9], 12,
18, 24, 30 dB
_3, 0, 3, 6, 9, 12,
[18], 24, 30 dB
[16:9], 4:3
[Auto], 4:3
On, [Off]
On, [Off]
On, [Off]
– –
– –
[Y], MIX
On, [Off]
80%
16:9
4:3 area
Safety
zone
Contents
Selects the gain value for each gain switch position
(Low, Middle, High) of RM-P9 when the standalone unit is installed in the unit.
(Note: Except under the above conditions, the setting change becomes
invalid.)
Selects the aspect ratio for the video signal output. (This setting is valid
only when the standalone unit BKP-5910/5910P is incorporated.)
Selects the aspect ratio for the viewfinder indication.
Auto
: Automatically selects according to the aspect
ratio selected by16:9/4:3 Mode on the Wide Screen page.
4:3
: Selects 4:3 regardless of the 16:9/4:3 Mode setting.
Selects whether the safety zone maker showing the 4:3 area is
indicated in the 16:9 mode, or not.
Turns on and off the 16:9 indication in the 16:9 mode on the viewfinder
screen.
(This setting is valid only when the DISPLAY switch is set to ON or OFF.)
Selects whether the 16:9 indication is displayed on the internal color-bar
in On Bars the16:9 mode, or not.
(This setting is valid only when the DISPLAY switch is set to ON or OFF.)
Does not function in the unit.
The panel switch (S650) on IF-538 board can select a signal to be
output at MONITOR connector (VBS, VF or RET)
Selects whether character signals displayed on the viewfinder screen
are mixed with the VBS signal when "VBS" is selected by the panel
switch (S650) on IF-538 board.
(Does not function in the unit.)
Selects a video signal to be output to the viewfinder.
Y
: Y = 0.3R+0.59G+0.11B; The same as a camera output signal
MIX : Y = 0.33R+0.33G+0.33B
Sets signals selectable by RGB switch.
On
: R-G, B-G
Off
: R, G, B
Safety Zone
90%
Not indicated
a)
Off
b)
BKP-5090
Advertisement
