Renfert MT2 Instruction Manual

ENGLISH
We are pleased that you decided to buy a MT2 Trimmer,
which will set new functional, performance, safety and design
standards. To ensure that you enjoy using this product for
many years, please follow these instructions carefully.

1. Description / Applications

The MT2 is a water-assisted trimmer unit for grinding plaster
models in dental laboratories.
DSS Disc-Stop-System:
The trimmer unit is fitted with a maintenance-free motor
brake. The trimmer disc will stop rotating within 5 seconds of
switching off the unit or opening the front cover. A hum will be
heard from the motor compartment which is normal.

2. Installation / Operation

Place the trimmer on a level surface, if possible in close proxi-
mity to a wash basin/plaster trap.
For installation of the trimming disc please see point 6.1.
When snapping the model tray (1) on the front cover (2) take
care that it fits perfectly (see Fig. 2). Use the outlet hose (10),
included with the trimmer, to connect it to the drain/plaster
trap.
Plaster Trimmer MT 2
No. 1801-0000
M5
Make sure the drainage pipe has a sufficient gradient.
Connect the water input hose (12) to your water supply,
ensuring that it has a suitable shut-off valve. Ascertain that
the washers in the screw-connectors are seated correctly.
Tighten the connectors, turn on the water and check that the
connectors are water-tight.
Ensure that the trimmer disc and the model tray are fitting
perfectly. Ensure that your mains voltage coincides with that
quoted on the rating plate. Once this check has been carried
out, insert the plug (11) into a mains socket. Switch on the
power switch (13) on the housing.
The water valve opens automatically thus supplying the trim-
mer with water.
The water consumption can be regulated using the
reduction valve (14) on the left, underside of the trimmer.
The MT2 trimmer is now ready for use.