Step Make It Working; Step 1：Power On; Step 2：Ready, Go; Step 3：Pause - Newland NLS-CM50 Integration Manual

4 Step Make it Working

After CM50 is installed/embedded into the deivce, connect to connectors (control and communication),the engine can be used follow
the 4 steps or different combinations, for general applcaition.
Step 1：Power On
Set Power Enable (Pin 8) from Low level to Hig level andthe engine goes to Ready Mode.
Step 2：Ready, Go!
2
Modify register via I C communication to make 0xFD as0x03, then CM50 goest to Continuous Mode 1, the engine will automatically
control CIS, Aiming LED, and Illumination LED, and output image frame.
Step 3：Pause
2
Modify register via I Ccommunication to make 0xFD as0x02, then CM50 goest to CIS Standby Mode, which pause CIS, Aiming LED,
Illumination LED. If needs to pause with lower current, modify register via I
Mode. Repeat Step 2 to go to continuously automatic control and image output status.
Step 4：Standby
2
Modify register via I C to make 0xFD as 0x01, CM50 goes to Ready Mode ; set Power Enable (Pin 8) to be low level, the engine goes
to Stanby Mode.
2
C to make 0xFD as 0x01, and the enginegoes to Ready
18