Table of Contents
Advertisement
Continuous Mode can be divided into three modes due to different PCLKs :
Continuous Mode 1：PCLK is 26MHz，CIS output 58 fps。
Continuous Mode 2： PCLK is 20MHz，CIS output 45 fps。
Continuous Mode 3： PCLK is 14MHz，CIS output 31 fps。
The lower PCLK, the lower power is consumed and lower heat will occur.
Imager Registers
The table below describes general registers and bits. Those registers and bits have no description are reserved and should not be used at
discretion.
Register
0xF0
0xF1
0xF2
0xF4 – Aimer
0xF5 -- Illumination
0xF8 – CIS Control
0xFD – Run Mode
17
Bit
-
ID 1
-
ID 2
-
ID 3
Bit 0
If set, when CIS is in exposure，aiming is on.
Bit 1
If set, when CIS is not in exposure，aiming is on.
If set, only when Pin 6(Aimer On) is high, allows aimer
Bit 2
to turn on with Bit 0/1 setting ; if Pin6 is low, aimer will
not turn on even Bit 0/1 is set.
Bit 0
If set, when CIS is in exposure, illumination is on.
Bit 1
If set, when CIS is in exposure, illumination is on.
If set, only when Pin7(Illumination On)is high, allows
Bit 3
illuminator to turn on with Bit 0/1 setting ; if Pin7 is low,
illuminator will not turn on even Bit 0/1 is set.
Bit 3
Row Flip Enable
Bit 4
Column Flip Enable
Bit 5
AEC Enable
0x01：Ready Mode
0x02：CIS Standby
Bit [7:0]
0x03：Continuous Mode 1
0x08：Continuous Mode 2
0x09：Continuous Mode 3
Desciption
default
Read/Write
0x01
R
0x05
R
0x76
R
0x02
W
0x01
W
0x20
W
0x01
W
Advertisement
Table of Contents
