VOLTCRAFT MS-229 Operating Instructions Manual page 26

5. Set the load selection switch (6) to set the test current. Please refer to the following table for correct setting.
Switch position
Battery voltage
Test current
6. Insert the test battery as indicated in the following diagram.
For round cells or button cells
Quit the stand-by mode by either pressing and holding the "MODE/START" button (4) for 3 seconds or operating the "ON/OFF"
switch (9).
26
Left Centre
1.2V/ 1.5V 3V/ 12V
30mA 6 – 24mA
Right
6V/ 9V
30 – 40mA
For 9V battery