Schematic Diagram - Sharp VC-MH705HM/LM Service Manual

www.freeservicemanuals.info
IMPORTANT SAFETY NOTICE:
BE SURE TO USE GENUINE PARTS FOR SE-
CURING THE SAFETY AND RELIABILITY OF
THE SET.
PARTS MARKED WITH " å " AND PARTS
SHADED (IN BLACK) ARE ESPECIALLY IMPOR-
TANT FOR MAINTAINING THE SAFETY AND
PROTECTING ABILITY OF THE SET.
BE SURE TO REPLACE THEM WITH PARTS OF
SPECIFIED PART NUMBER.
SAFETY NOTES:
1. DISCONNECT THE AC PLUG FROM THE AC
OUTLET BEFORE REPLACING PARTS.
2. SEMICONDUCTOR HEAT SINKS SHOULD BE
REGARDED AS POTENTIAL SHOCK HAZ-
ARDS WHEN THE CHASSIS IS OPERATING.

SCHEMATIC DIAGRAM

NOTES:
1. The unit of resistance "ohm" is omitted (k=1000
2. All resistors are 1/16 watt, unless otherwise
3. The unit of capacitance "F" is omitted ( µ = µ F,
4. The values in parentheses are the ones in the
VOLTAGE MEASUREMENT CONDITIONS:
1. DC voltages are measured between points indi-
2. Voltages are measured with 10000 µ V B & W or
WAVEFORM MEASUREMENT CONDITIONS:
10000 µ V 87.5 percent modulated colour bar signal
is fed into tuner.
CAUTION:
This circuit diagram is original one. Therefore there
may be a slight difference from yours.
63
Digitized in Heiloo the Netherlands
ohm, M=1 Meg ohm).
noted.
p= µµ F).
PB mode; the values without parentheses are
the ones in the REC mode.
cated and chassis ground by VTVM, with
AC230V~240V/50Hz supplied to unit and all
controls are set to normal viewing picture unless
otherwise noted.
colour noted.
VC-MH705HM/LM
6/17/2019
VC-MH815HM/LM,MH85HM
VC-MH715HM,MH835HM
Not for sale!