Operating The Device - ProMed BDP-200 Instruction Leaflet

OPERATING THE DEVICE

Checking/replacing the battery
• To replace/insert the batteries, remove the cover of the battery compartment (J) and
insert 4 batteries 1.5V AAA (K). Ensure that the batteries are inserted with their right
polarity (+/-). After inserting, close the battery compartment again.
• Promed BDP-200 checks the charge status of the batteries; the battery status display
(10) shows the low capacity of the battery and the
case, the batteries must be replaced immediately, otherwise the measurement result will
be falsified.
Note:
When the battery is changed, all stored measured values will be deleted.
After a battery change, date and time must be set again.
Caution:
• Remove the batteries when the device is not used for a longer time.
• Do not use old and new batteries or different battery types at the same time.
• Warning: If batteries leak and come in contact with skin or eyes, immediately clean these
areas with plenty of water.
• Batteries shall only be used by adults. Keep the batteries out of the reach of children.
• It is recommended to use batteries of the same or similar type.
• Remove empty batteries from the device.
• Dispose of the batteries according to the instructions of the battery manufacturer.
• Do not use batteries when they have expired.
Note:
If the power supply is interrupted or the battery status display (10) lights up during
measurement, the measurement must absolutely be repeated.
Connection of the arm cuff
To connect the arm cuff (I) to the device, insert the tube connector (H) into the tube connection
(G). Please ensure that the connector is inserted into the device without using force.
symbol appears. If this is the
27
DE
EN
FR
IT
ES
NL
RU
PL
TR
AR