Table of Contents
Advertisement
2-1-4. Initial Settings
When switch position is changed during adjustment, be
sure to reset it to the former position after adjustment.
BKP-590
n
When switching the following switches from a customer-
set position, it is recommended to record the setting state
of the customer in the table below.
After adjustment is complete, be sure to return the switches
to their customer-set position.
Board
Switch
Initial setting
IF-562
S1
TALK
S2-1
OFF (NTSC)
S2-2
ON
S2-3
OFF
S2-4
OFF
S2-5
OFF
S2-6
CAM A
S3
OFF
MD-111
S1
ON
S2
ON
S3
ON
S402
NTSC
MSU-700 Operation Panel
• CAM POWER/Signal output select buttons
ALL button
CAM PW button
TEST 1 button
TEST 2 button
BARS button
CLOSE button
• CAM/CCU Function ON/OFF buttons
KNEE OFF button
DETAIL OFF button
MATRIX OFF button
AUTO KNEE button
• Others
GAMMA OFF button
MASTER GAIN button
BKP-590
Customer-set position
→ OFF (Stays out)
→ ON (Stays lit)
→ OFF (Stays out)
→ OFF (Stays out)
→ OFF (Stays out)
→ ON (Stays lit)
→ OFF (Stays lit)
→ OFF (Stays lit)
→ OFF (Stays lit)
→ OFF (Stays out)
→ ON (Stays out)
→ 0 (0 dB)
2-1-5. Adjustment Items
MD-111 Board
2-2-1.
VCO DC Set Adjustment
2-2-2.
Y REF Level Adjustment
2-2-3.
Y/SKIN DC Balance Adjustment
2-2-4.
Y/SKIN 90° Adjustment
2-2-5.
R-Y REF Level Adjustment
2-2-6.
B-Y REF Level Adjustment
2-2-7.
R-Y/B-Y Carrier Balance Adjustment
2-2-8.
R-Y/B-Y DC Balance Adjustment
2-2-9.
R-Y/B-Y 90° Adjustment
2-2-10. 67.5 MHz TRAP Adjustment
TR-92 Board
2-3-1.
MIC RF Adjustment
2-3-2.
MIC Deviation Adjustment
2-3-3.
INCOM RF Adjustment
2-3-4.
INCOM Deviation Adjustment
2-3-5.
DATA RF Adjustment
2-3-6.
INCOM Demodulation Adjustment
2-3-7.
PGM Demodulation Adjustment
2-3-8.
DATA Demodulation Circuit Adjustment
2-3-9.
H CONT Demodulation Circuit Adjustment
IF-562 Board
2-4-1.
Battery Alarm Set Adjustment
2-4-2.
Sample Pulse Phase Adjustment
2-1. Preparation
2-3(E)
Advertisement
Table of Contents
